Stihl HS 45 Notice D'emploi page 13

Masquer les pouces Voir aussi pour HS 45:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

If the engine is cold (choke set to l)
Pull the starter rope five times.
N
Set choke lever to j and
N
continue cranking until the engine
N
runs.
If conditions are unfavorable and the
engine does not start after 10 pulls with
the choke lever set to j :
Set choke to l and pull starter
N
rope five times. Set choke to j and
continue cranking.
If the engine is warm (choke set to j)
Continue cranking until the engine
N
runs.
As Soon as Engine Runs
Blip the throttle trigger – the engine
N
settles down to idle speed.
If the engine stops during warm-up or
acceleration
Repeat the starting procedure as
N
described under "If the engine is
cold".
WARNING
Make sure the carburetor is correctly
adjusted. The cutting blades must not
move when the engine is idling.
Your machine is now ready for
operation.
Stopping the Engine
Move the stop switch to O.
N
HS 45
Other Hints on Starting
If the engine does not start
Make sure all settings are correct
N
(choke shutter, throttle trigger in
starting throttle position, stop switch
to I).
Repeat the starting procedure.
N
If the engine still does not start
Remove the spark plug – see
N
"Spark Plug".
Dry the spark plug.
N
Open the throttle wide.
N
Crank the engine several times with
N
the starter to clear the combustion
chamber.
Install the spark plug – see "Spark
N
Plug".
Move the stop switch to I.
N
Set choke lever to j – even if the
N
engine is cold.
Now start the engine.
N
If fuel tank has been run completely dry
and then refueled
6
Press the manual fuel pump
N
bulb (6) at least five times – even if
the bulb is filled with fuel.
Now start the engine.
N
English
11

Publicité

Chapitres

Table des Matières
loading

Table des Matières