Nedo Primus2 H2N Mode D'emploi page 33

EN Operating instructions
7 Switch on the PRIMUS 2 H2N/H2N+
AUTOMATIC operating mode is the default setting each time the laser is swit-
ched on.
NOTE
Despite careful setting up, warnings and error messages can appear in the display in
AUTOMATIC operating mode due to external influences and strong vibrations. For
description and remedies, see Chapter 15.
7.1 AUTOMATIC operating mode
In AUTOMATIC operating mode, the laser automatically levels itself horizon-
tally within a range of ±5° and compensates for minor vibrations.
Switch on the laser
During and for 30 seconds after the levelling the laser can be placed in the fi-
nal vertical position/height without warning, e.g. using an elevator tripod.
After 30 seconds, the TILT alarm function is switched on. A vertical movement
of the laser or vibration triggers the warning C01. For description and reme-
dies, see Chapter 15.
AUTOMATIC operating mode is active. The following functions can be invoked:
Use the
Use the
laser does not detect any vibrations and does not level itself horizontally in
MANUAL operating mode.
The tilt of the axes can only be entered in AUTOMATIC operating mode. The
set tilt values are retained in MANUAL mode but are not shown on the display.
Use the
Laser levels itself
horizontally
button to invoke the TILT axes function (Chapter 8).
button to switch to MANUAL operating mode (Chapter 7.2). The
button to exit the operating mode, switch off the laser.
Levelling is finished, the flashing symbol goes
out, the laser is active
33