Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
en Getting to know your appliance
Before using your appliance
for the first time
Remove information material,
1.
adhesive tape and protective film.
Clean the appliance.
2.
~ "Cleaning" on page 26
Electrical connection
Caution!
Do not connect the appliance to
electronic energy saver plugs.
Note: You can connect the appliance
to mains-controlled and sine-controlled
inverters.
Mains-controlled inverters are used for
photovoltaic systems which are
connected directly to the national grid.
Sine-controlled inverters must be used
for isolated applications. Isolated
applications, e.g. on ships or in
mountain lodges, which are not
connected directly to the national grid.
After installing the appliance, wait at
1.
least 1 hour before connecting it to
prevent damaging the compressor.
Connect the appliance via a
2.
correctly installed socket.
The socket must comply with the
following data:
Socket with
Conductor
Fuse
Outside Europe: Check whether the
indicated current type of the
appliance corresponds with the
values of your power supply.
Appliance specifications are on the
rating plate.
~ "Getting to know your appliance"
on page 22
22
220 V ... 240 V
50 Hz
10 A ... 16 A
Connect the appliance to a socket
3.
near the appliance.
The socket must also be freely
accessible following installation of
the appliance.
:
Warning
Risk of electric shock!
If the length of the mains cable is
inadequate, never use multiple
sockets or extension leads.Instead,
please contact Customer Service for
alternatives.
*
Getting to know your
appliance
F old out the last page with the
G e t t i n g t o k n o w y o u r a p p l i a n c e
diagrams. The appliance and diagrams
may differ according to features.
Appliance
~ Fig. !
Refrigerator compartment
#
Cool-fresh compartment
+
(...H Controls
Lighting
P
Partition with humidity
X
controller
Vegetable container
`
Cool-fresh container
h
Rating plate
)"
Tray for large bottles
)*
Publicité
Chapitres
Table des Matières
