Attaching The Fan Blades; Installing The Mounting Plate - Kichler 52" Terra Select Manuel D'instructions

ATTACHING THE FAN BLADES

CAUTION: Remove the five rubber shipping blocks attached to the face of the motor.
These blocks keep the motor from shifting during shipping and MUST be removed during
installation.
Step 1. Attach a blade to a blade bracket using the screws and fiber washers provided.
(Fig. 14)
Make sure the blade is straight when set on the blade bracket. Tighten each mounting
screw until the fiber washer is slightly compressed. Repeat this procedure for each blade.
Step 2. Attach each blade assembly to the motor using the "Pre-Installed" mounting
screws in the blade bracket. (Fig 14)

INSTALLING THE MOUNTING PLATE

Step 1. Loosen the two screws on the mounting ring attached to the motor shaft
and "remove" and save the third screw. (Fig. 15)
Step 2. Place the key holes on the mounting plate over the 2 screws previously
loosened from the mounting ring, turn mounting plate until it locks in place at the
narrow section of the key holes. Secure by tightening the 2 screws previously
loosened and the one previously removed. (Fig. 15)
Screws
Fiber
washers
Blades
Screws
Blade brackets
Fig. 14
Mounting ring
Mounting
plate
Screws
Fig. 15
52" Terra Select |
13