Attaching The Fan Blades; Installing The Mounting Plate - Kichler Sutter Place Select Manuel D'instructions

ATTACHING THE FAN BLADES

CAUTION: Remove the five rubber shipping blocks attached to the face of the motor.
These blocks keep the motor from shifting during shipping and MUST be removed
during installation.
Step 1. Attach a blade to a blade bracket using the screws and fiber washers provided.
(Fig. 15)
Make sure the blade is straight when set on the blade bracket. Tighten each mounting
screw until the fiber washer is slightly compressed. Repeat this procedure for each
blade.
Step 2. Attach each blade assembly to the motor using the "Pre-Installed" mounting
screws in the blade bracket. (Fig 15)

INSTALLING THE MOUNTING PLATE

Step 1. Loosen the two screws on the mounting ring attached to the motor shaft and
"remove" and save the third screw. (Fig. 16)
Step 2. Place the key hole slots on the mounting plate over the two screws previously
loosened on the mounting ring.
Turn the mounting plate until is locks in place at the narrow section of the key hole slots.
Tighten both key hole screws and replace the third screw previously removed and
tighten securely.
12 | KICHLER.COM
Screws
Blade Brackets
Fig. 15
Mounting Ring
Mounting Plate
Screws
Fig. 16
Screws
Fiber
Washers
Blades