ATTACHING THE FAN BLADES
NOTE: Before continuing, make sure the power is disconnected by turning off
the circuit breaker of removing the fuse at the circuit box.
Step 1. Slide blades through the blade slots in motor housing and attach to
motor brackets using the screws and blade plates. Make sure the screws
securing the blade to blade bracket are tight and are properly seated. (Fig. 16)
INSTALLING THE LIGHT PLATE
Step 1. Remove the screw marked with a dot label on the mounting plate and
save for later use, and slightly loosen the other two screws. Attach the light
plate to mounting plate using the two key slots in the light plate. Replace the
previously removed screw and securely tighten all 3 screws. (Fig. 17)
12 | KICHLER.COM
Blade Slot
Blade Washer
Blade Bracket
Blade Screw
Fig. 16
Mounting
Plate
Light Plate
Screw
Fig. 17
Blade