Attaching The Fan Blades; Installing The Light Plate - Kichler 85 GENTRY XL Manuel D'instructions

ATTACHING THE FAN BLADES

Step 1. Align the holes from the blade and blade support plate to the
holes from the blade arms, and secure the blade in place with screws
provided. (Fig. 15)
Step 2. Repeat this process to attach the other two blades.

INSTALLING THE LIGHT PLATE

Step 1. Loosen the two screws on the mounting ring attached to the
motor shaft and "remove" and save the third screw. (Fig. 16)
Step 2. Place the key hole slots on the light plate over the two screws
previously loosened on the mounting ring.
Turn the light plate until is locks in place at the narrow section of the key
hole slots.
Tighten both key hole screws and replace the third screw previously
removed and tighten securely.
14 | KICHLER.COM
Screws
Blade support
plates
Blades
Fig. 15
Blade arms
Light plate Mounting ring
Screws
Fig. 16