Safety Rules - Kichler 85 GENTRY XL Manuel D'instructions

SAFETY RULES

READ AND SAVE THESE INSTRUCTIONS
WARNING: FOR CANADA, THIS FAN MUST BE SECURED DIRECTLY TO THE
BUILDING STRUCTURE / CEILING JOIST. DON'T SECURE THIS FAN TO AN
OUTLET BOX.
1. CAUTION - RISK OF SHOCK-
Disconnect Power at the main circuit breaker panel or main fusebox
before starting and during the installation.
2. WARNING: This fixture is intended for installation in accordance with the
National Electrical Code (NEC) and all local code specifications. If you are
not familiar with code requirements, installation by a certified electrician
is recommended.
3. WARNING: To reduce the risk of fire, electric shock, or personal Injury
mount to an outlet box marked "Acceptable For Fan Support of up to 22.7
kg (50 lbs)". For outlet box mounting, use mounting screws provided with
the outlet box. Most outlet boxes commonly used for the support of light
fixtures are not acceptable for fan support and may need to be replaced.
Due to the complexity of the installation of this fan, a qualified licensed
electrician is strongly recommended.
4. All wiring must be in accordance with the National Electrical Code ANSI/
NFPA 70 and local electrical codes. Electrical installation should should
be performed by a qualified licensed electrician.
5. The outlet box and support structure must be securely mounted and
capable of reliably supporting a minimum of 50 pounds. Use only cULus
Listed outlet boxes marked "FOR FAN SUPPORT".
WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK OR PERSONAL
INJURY, MOUNT FAN TO OUTLET BOX MARKED "ACCEPTABLE FOR FAN SUPPORT".
4 | KICHLER.COM
6. CAUTION: The fan must be mounted with a minimum of 2.1 m (7 feet)
clearance from the trailing edge of the blades to the floor.
7. To operate the reverse function on this fan, press the reverse button while
the fan is running.
8. Avoid placing objects in the path of the blades.
9. To avoid personal injury or damage to the fan and other items, be
cautious when working around or cleaning the fan.
10. WARNING: Make sure the power is disconnected before cleaning the fan.
11. Do not use water or detergents when cleaning the fan or fan blades. A dry
dust cloth or lightly dampened cloth will be suitable for most cleaning.
12. After marking electrical connections, spliced conductors should be turned
upward and pushed carefully up into outlet box. The wires should be
spread apart with the grounded conductor and the equipment-grounding
conductor on one side of the outlet box.
13. Electrical diagrams are reference only. Light Kits that are not packed with
the fan must be cULus Listed and marked suitable for use with the model
fan you are installing. Switches must be cULus General Use Switches.
Refer to the Instructions packaged with the light kits and switches for
proper assembly.
14. Suitable for damp location.
15. Use only with light kits marked suitable for damp location.
16. All set screws must be checked, and retightened where necessary, before
installation.
WARNING: TO REDUCE THE RISK OF PERSONAL INJURY, DO NOT BEND THE
BLADE BRACKETS (ALSO REFERRED TO AS FLANGES) DURING ASSEMBLY
OR AFTER INSTALLATION. DO NOT INSERT OBJECTS IN THE PATH OF
BLADES.