Safety Rules - Kichler 330162 Manuel D'instructions

SAFETY RULES

1. CAUTION -RISK OF SHOCK-
Disconnect Power at the main circuit breaker panel
or main fusebox before starting and during the
installation.
2. WARNING: This fixture is intended for installation in
accordance with the National Electrical Code (NEC)
and all local code specifications. If you are not familiar
with code requirements, installation by a certified
electrician is recommended.
3. WARNING: To reduce the risk of fire or electric shock,
do not use this fan with any solid-state speed control
device.
4. WARNING: To reduce the risk of fire, electric shock,
or personal Injury mount to an outlet box marked
"Acceptable For Fan Support of up to 22.7 kg (50
lbs)". For outlet box mounting, use mounting screws
provided with the outlet box.
5. WARNING: To reduce the risk of fire, electric shock
or personal injury, mount fan to outlet box marked
"acceptable for fan support".
6. The outlet box and support structure must be securely
mounted and capable of reliably supporting a minimum
of 50 pounds. Use only cULus Listed outlet boxes
marked "FOR FAN SUPPORT".
7. The fan must be mounted with a minimum of 2.1 m
(7 feet) clearance from the trailing edge of the blades
to the floor.
8. WARNING: Do not operate reversing switch while fan
blades are in motion. Fan must be turned off and blades
stopped before reversing blade direction.
4
| KICHLER.COM
9. Avoid placing objects in the path of the blades.
10. To avoid personal injury or damage to the fan and other
items, be cautious when working around or cleaning
the fan.
11. WARNING: Make sure the power is disconnected
before cleaning the fan.
12. Do not use water or detergents when cleaning the fan
or fan blades. A dry dust cloth or lightly dampened
cloth will be suitable for most cleaning.
13. After marking electrical connections, spliced
conductors should be turned upward and pushed
carefully up into outlet box. The wires should be
spread apart with the grounded conductor and the
equipment-grounding conductor on one side of the
outlet box and the ungrounded conductor on the other
side of the outlet box.
14. Electrical diagrams are reference only. Light Kits that
are not packed with the fan must be cULus Listed
and marked suitable for use with the model fan you
are installing. Switches must be cULus General Use
Switches. Refer to the Instructions packaged with the
light kits and switches for proper assembly.
15. WARNING: To reduce the risk of personal injury, do not
bend the blade brackets (also reffered to as flanges)
during assembly or after installation. Do not insert
objects in the path of blades.
16. All set screws must be checked, and retightened where
necessary, before installation.