Safety Rules - Kichler Starkk 52 Manuel D'instructions

SAFETY RULES

1. To reduce the risk of electric shock, ensure electricity has been
turned off at the circuit breaker or fuse box before beginning.
2. All wiring must be in accordance with the National Electrical
Code (NEC) and local electrical codes. Electrical installation
should be performed by a qualified licensed electrician
3. WARNING: Suitable for use with solid-state speed controls.
4. WARNING: To reduce the risk of personal injury, use only the
two steel screws (and lock washers) provided with the outlet
box for mounting to the outlet box. Most outlet boxes
commonly used for the support of lighting fixtures are not
acceptable for fan support and may need to be replaced,
consult a qualified electrician if in doubt.
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK OR
PERSONAL INJURY, MOUNT FAN TO OUTLET BOX
MARKED "ACCEPTABLE FOR FAN SUPPORT".
5. The outlet box and support structure must be securely
mounted and capable of supporting a minimum of 50
pounds. Use only UL (cUL for Canadian Installation) Listed
outlet boxes marked "FOR FAN SUPPORT".
6. The fan must be mounted with a minimum of 7 feet
clearance from the trailing edge of the blades to the floor.
7. Do not operate reversing switch while fan blades are in
motion. Fan must be turned off and blades stopped before
reversing blade direction.
8. Avoid placing objects in the path of the blades.
4 | KICHLER.COM
9. To avoid personal injury or damage to the fan and other items, be
cautious when working around or cleaning the fan.
10. Do not use water or detergents when cleaning the fan or fan
blades. A dry dust cloth or lightly dampened cloth will be suitable
for most cleaning.
11. After making electrical connections, spliced conductors should be
turned upward and pushed carefully up into outlet box. The wires
should be spread apart with the grounded conductor and the
equipment-grounding conductor on one side of the outlet box.
12. Electrical diagrams are reference only. Light kits that are not
packed with the fan must be Listed and marked "suitable for use"
with the model fan you are installing. Switches must be General
Use Switches. Refer to the Instructions packaged with the light kits
and switches for proper assembly.
WARNING
TO REDUCE THE RISK OF PERSONAL INJURY, DO NOT BEND
THE BLADE BRACKETS (ALSO REFERRED TO AS FLANGES)
DURING ASSEMBLY OR AFTER INSTALLATION. DO NOT INSERT
OBJECTS IN THE PATH OF THE BLADES.
SPECIAL NOTICE
This appliance is equipped with a "Wattage Limiting Device"
required by the United States Department of Energy. The device
has been installed at the factory and can not be removed.
Installing Lamps in excess of 190 total watts will disable the
unit's light fixture. If this should happen, you will need to reset
the lighting fixture by turning the power off to the ceiling fan
and/or light fixture, reinstalling lamps totaling less than 190 watts
and then turning the power back on.