Attaching The Fan Blades; Installing The Switch Housing - Kichler BASICS PRO PATIO 52 Manuel D'instructions

ATTACHING THE FAN BLADES

CAUTION: Remove the rubber shipping blocks attached to the face of the motor. These
blocks keep the motor from shifting during shipping and MUST be removed during
installation.
Step 1. Attach the blade to the blade bracket using the screws and washers as shown in
Figure 14. Start screw into bracket. Repeat for the two remaining screws.
Step 2. Make sure the blade is straight and tighten each screw.
Step 3. Fasten blade assembly to motor using "Pre-Installed" mounting screws in the
blade bracket.

INSTALLING THE SWITCH HOUSING

NOTE: Before continuing installation, confirm that the power is still turned off at the main
circuit breaker or by removing the correct fuse. Turning the power off using a wall switch is
not sufficient to prevent electrical shock.
Step 1. While holding the switch housing under your ceiling fan, push the square wire
connectors together. One from the fan and one from the switch housing (Fig. 15).
NOTE: These connectors are color coded and will ONLY engage when the colored strips
are matched (aligned).
Step 2. Carefully push all the wires into the switch housing. Attach the switch housing to
the mounting ring with the screws provided. Make sure each screw is tight (Fig. 15).
Screws
Blade brackets
Fig. 14
Wire connector
Mounting ring
Switch housing
Fig. 15
52" BASICS PRO PATIO | 13
Screws
Washers
Blades
Screws