Installing The Light Kit - Kichler Starkk 42 Manuel D'instructions

INSTALLING THE LIGHT KIT

NOTE: Before continuing installation, confirm that the power is still turned off
at the main circuit breaker or by removing the correct fuse. Turning the power
off using a wall switch is not sufficient to prevent electrical shock.
Step 1. Remove one of the three screws in light plate and keep for later use,
slightly loosen the other remaining screws. (Fig. 18)
Step 2. Securely attach the 9-pin connector to the wiring harness socket
within the motor assembly (Fig. 19)
Light Plate
Fig. 18
LED Light Kit
Fig. 19
42"/52" Starkk
LED | 13
™