Installing The Light Kit - Kichler Spyn LED 52 Manuel D'utilisation

INSTALLING THE SWITCH HOUSING
Step 2. Place the two slot holes on the switch housing over the 2 screws
previously loosened from the mounting plate. Rotate the switch housing
until it locks in place at the narrow end of the key holes. Secure by tightening
the 2 screws previously loosened and the one previously removed. (Fig. 18)

INSTALLING THE LIGHT KIT

NOTE: Before continuing installation, confirm that the power is still turned
o at the main circuit breaker or by removing the circuit fuse. Turning the
power o using a wall switch is not su cient to prevent electrical stock.
Step 1. Remove one of the three screws pre-installed on the outer edge side
of the switch housing and save for later use. Loosen the other two (do not
removed. (Fig. 19)
Mounting Plate
Swith Housing
Screw
Fig. 18
Swith Housing
Screw
Fig. 19
52" Spyn LED 13