INSTALLING THE WALL CONTROL
Outlet Box
Switch
All wiring must be in accordance with the National Electrical Code and local electrical codes.
Wall Plate
Electrical installation should be performed by a qualified licensed electrician. Select a location
to install your wall control. You can replace an existing wall switch, or install the wall control on
ANY flat surface.
Fig. 22
NOTE: SWITCH INSTALLATION MUST COMPLY WITH ALL LOCAL AND NATIONAL
ELECTRIC CODE .
Wall Plate
Wall Control
Step 1. Remove the existing wall plate and the old switch from the wall outlet box, place the
new control and wall plate. Wire nut the lead wire (hot) together and push back inside
Outlet Box
the outlet box. (Fig. 22) or select the desired location with a new wall outlet box.
Step 2. Use the screws provided to secure the wall control to the outlet box.(Fig. 23)
Fig. 23
52" Spyn
LED
15