Installing The Light Kit To Switch Housing; Installing The Light Kit Assembly - Kichler 52" Terra Select Manuel D'instructions

INSTALLING THE LIGHT KIT TO SWITCH HOUSING

Remove and discard the center plug from the switch housing. Attach the light kit to
the switch housing by feeding the light kit wires (black and white) through the hole
in the center of the switch housing and then screw the threaded pipe on the light kit
into the same hole. Add a nut & lock washer to the threaded pipe on the inside of the
switch housing and tighten.
Attach the wires from the light kit to the wires inside the switch housing by pushing
the polarized connections together. (Fig.16)
- White wire to White wire
- Black wire to Blue wire

INSTALLING THE LIGHT KIT ASSEMBLY

NOTE: Before starting installation, disconnect the power by turning off the circuit
breaker or removing the fuse at fuse box.
Step 1. Loosen the 3 screws from the mounting plate.
Step 2. Raise and hold the light kit assembly close to the mounting plate. Push the
nine pin square wire connectors together. One from the fan and one from the light
kit assembly. (Fig. 17)
Step 3. Tuck the connections neatly into the switch housing and attach the light kit
assembly to the ceiling fan. Place the key hole slots on the top edge of the switch
housing over the mounting screw heads on the mounting plate. Turn the switch
housing until the screw heads are at the narrow end of the key hole slots. (Fig.17)
Tighten all of the screws.
14 | KICHLER.COM
Nut
Lock washer
Switch housing
Center
plug
Light kit
Fig. 16
Connection plug
Mounting plate
Screws
Light kit
Fig. 17