Installing The Light Kit And Glass - Kichler 54 Daya LED Manuel D'instructions

INSTALLING THE LIGHT KIT AND GLASS

NOTE: Before continuing installation, confirm that the power is still turned off
at the main circuit breaker or by removing the circuit fuse. Turning the power
off using a wall switch is not sufficient to prevent electrical stock.
Step 1. Connect the 2 single pin connectors from the light kit to the 2 single pin
connectors from motor assembly. Align three round holes on the light kit with
the holes on the switch housing, securely tighten with three (3) screws found
in light kit hardware pack. (Fig. 21)
Step 2. Secure the glass to switch housing by twisting in a clockwise direction,
twist the glass gradually until it snaps on to the switch housing. Do not over-
tighten. (Fig. 22)
Step 3. Hold the light case up to the switch housing, align with 4 holes and
securely tighten with 4 screws found in the hardware pack.(Fig. 23)
14 | KICHLER.COM
Switch
Housing
Glass
Fig. 22
Screw
Light Kit
Screw
Fig. 21
Light Case
Fig. 23