Hanging The Fan - Kichler Sutter Place Select Manuel D'instructions

HANGING THE FAN

NOTE: This ceiling fan is supplied with two types of hanging assemblies; a downrod
and canopy mounting system and a "close to ceiling" Canopy ONLY system. The
"close-to- ceiling" installation is recommended in rooms with less than 8-foot
ceilings or in areas where additional space is desired from the floor to the fan
blades. Once you have selected which mounting system you will use, proceed with
the following instructions. Where necessary, each section of the instructions will
note the different procedures to follow for the two types of mounting.
REMEMBER to turn off the power before you begin.
To properly install your ceiling fan, follow the steps below.
Step 1. Remove the decorative canopy bottom cover from the canopy. (Fig. 5)
Step 2. Loosen the four screws on the top of the canopy. Remove the two non-
slotted screws and loosen the slotted screws. This will enable you to remove the
ceiling mounting bracket. (Fig. 5)
Step 3. Remove the ceiling mounting bracket from the canopy by loosening the
two screws on the bottom of the ceiling mounting bracket. Turn the canopy
counterclockwise and remove. (Fig. 5)
Step 4. Pass the 120 volt supply wires from the ceiling outlet box through the
center of the ceiling mounting bracket. (Fig. 6)
Step 5. Attach the ceiling mounting bracket to the outlet box using the screws and
washers included with the outlet box. (Fig. 6)
STANDARD CEILING INSTALLATION
Step 1. Remove the hanger ball from the downrod assembly by loosening the set
screw, removing the cross pin and sliding the ball off the rod. (Fig.7)
Step 2. Loosen the two set screws and remove the hitch pin and retaining clip from
the coupling on top of the motor assembly. (Fig. 7)
Screws
Ceiling Mounting Bracket
Canopy
Fig. 5
Canopy Cover
CUL Listed
Outlet Box
Ceiling
Mounting
Bracket
Hook
Mounting Screws
Fig. 6
120V Wires (supplied with electrical box)
Cross Pin
Hanger Ball
Set Screw
Supply Wires
Downrod
Coupling Cover
Coupling
Set Screws
Set Screws
Hitch Pin
Fig. 7
Sutter Place
™
Screws
Washers
Canopy
Retaining Pin
7
Select |