Hanging The Fan - Kichler 52 Range LED Manuel D'instruction

HANGING THE FAN

REMEMBER REMEMBER to turn off the power before you begin installation. This is
necessary for your safety and also the proper programming of the control
system. To properly install your ceiling fan, follow the steps below.
Step 1. Before attaching fan to outlet box (not included), ensure the outlet box Step 1.
is securely fastened to at least two points to a structural ceiling member
(a loose box will cause the fan to wobble). Install the screws and washers
included with the outlet box. NOTE: NOTE: Do not lock the screws completely, just
lock half.
Pass the 120 volt supply wires form the ceiling outlet box through the center
of the ceiling mounting bracket.(Fig. 5)
Step 2. Align the slot holes on the mounting bracket with the screws, and Step 2.
push the mounting bracket to the screws, then tighten the screws. (Fig. 6
and 7)
Outlet Box
Washer
Mounting Bracket
Fig. 5
Fig. 6
Fig. 7
52" Range LED | 7
Screw