Installing The Switch Housing - Kichler 52 Range LED Manuel D'instruction

INSTALLING THE SWITCH HOUSING

Step 1. Step 1. Remove one of three screws which preinstalled on mounting plate and Remove one of three screws which preinstalled on mounting plate and
keep for later use. Loosen the other two (do not remove). Place the two slot keep for later use. Loosen the other two (do not remove). Place the two slot
holes on the switch housing over the 2 screws previously loosened from the holes on the switch housing over the 2 screws previously loosened from the
mounting plate. Rotate the switch housing until it locks in place at the narrow mounting plate. Rotate the switch housing until it locks in place at the narrow
end of the key holes. Securely by tightening the 2 screws previously loosened end of the key holes. Securely by tightening the 2 screws previously loosened
Mounting Plate
Screw
and the one previously removed. (Fig. 20) and the one previously removed. (Fig. 20)
Fig. 20a
Switch Housing
Screw
Fig. 20b
14 | KICHLER.COM