Display Alarms - Dulevo SPARK 1000 BH Mode D'emploi Et D'entretien

1000 BH - 1000 EH - 1000 YH
BRUSH MOTOR
TRIPPED
BRAKE
STAND-BY
RELEASE ACCELERATOR
EEPROM 1 FAULT
DRIVE CONTROL
CUTOUT TRIPPED
ACCELERATOR FAULT
MAX. SPEED POTENTIOM-
ETER FAULT
UNDERVOLTAGE FAULT
OVERVOLTAGE FAULT
RELAY FAULT
HPD
MOSFET FAULT
EEPROM 2 FAULT

DISPLAY ALARMS

CUTOUT The brush motor has overheated.
The parking brake is engaged or the drive motor has over-
heated.
The driver detection microswitch is not detecting an operator.
Incorrect starting sequence. Release the accelerator pedal
when starting.
Replace the display board.
BOARD The drive control board has overheated.
There is a problem with the accelerator cable.
There is a fault in the maximum speed potentiometer cabling.
Check the batteries.
Check the batteries.
Replace the drive control board.
Check the accelerator pedal. Switch the machine off and back
on with the accelerator released.
Replace the drive control board.
Replace the drive control board.
2014-07
English
EN-45