Adjusting The Side Brushes; Replacing/Installing The Suction Filter - Dulevo SPARK 1000 BH Mode D'emploi Et D'entretien

1000 BH - 1000 EH - 1000 YH

Adjusting the side brushes

Never operate the machine without the side brushes installed.
The side brushes direct dirt and debris towards the centre of the machine. The most efficient height
for this purpose is when the side brushes gently touch the floor. Proceed as follows to increase or
reduce the pressure of the side brushes on the floor, if necessary.
► Lower the side brushes into work position (fig. 21).
► Loosen the two locking screws under the brush lifting knob (fig. 22).
► Manually move the brush to the required position.
► Tighten the locking screws again (fig. 22).
► Return the brushes to idle position.
21

Replacing/installing the suction filter

This operation must be performed with the machine switched off and the key removed.
The suction filter makes a major contribution to the efficiency of the whole machine.
Its correct maintenance keeps the machine at maximum efficiency at all times. If the sweeper begins
to raise dust as it sweeps, check the condition of the suction filter.
The suction filter can be cleaned in two ways.
Semiautomatic filter cleaning:
► This method provides a quick and easy way to keep the suction filter clean and ready for
work. Press and hold the filter shaker button for a number of seconds, then repeat four or
five times. On BH versions, shut off suction with the suction control lever before pressing
the filter shaker button.
! WARNING!
22
! DANGER!
2014-07
English
EN-37