Operating The Bh Versions; Emptying The Bottom Unloading Debris Bin - Dulevo SPARK 1000 BH Mode D'emploi Et D'entretien

English

Operating the BH versions

► Sit correctly in the seat.
► Release the parking brake.
► Move the engine speed control lever to START position.
► Pull out the choke.
► Move the engine drive lever to position 1-START and hold it there while turning the ignition
key to START position.
Do not engage the starter motor for more than five seconds at a time. If the engine fails to
start, release the ignition key and wait ten seconds before trying again.
► Allow the ignition key to return to ON position as soon as the engine starts and release the
engine drive lever.
► Press on the direction selector pedal to move off. Press the right side to move forwards.
Press the left side to move backwards.
► Lower the side brushes.
► Lower the main brush.
► Adjust the suction control lever to obtain the required strength of suction.
► Press the flap lift pedal only when you need to pick up large but light objects.
► Cleaning quality depends largely on the cleanliness of the suction filter. Operate the filter
shaker at intervals suitable to the environment in which you are using the machine.

Emptying the bottom unloading debris bin

When emptying the bin, always wear a mask to protect the respiratory tract from the dust
Before emptying the debris bin, operate the filter shaker for 30 seconds to clean the filter
► Release the bin lock (fig. 14).
► Pull out the rear bin by means of its handle.
► Take the bin (which is fitted with wheels) to the rubbish collection point and empty it.
EN-30
! WARNING!
! WARNING!
which is always present during this operation.
! WARNING!
14
2014-07
1000 BH - 1000 EH - 1000 YH