Operating Modes; Exhaust Air Mode; Circulating-Air Mode; Operation - Gaggenau AW 2 Séries Notice D'utilisation Et De Montage

Operating modes

This appliance can be used in exhaust-air mode or

circulating-air mode.

Exhaust air mode

The air which is drawn in is cleaned by
the grease filters and conveyed to the
exterior by a pipe system.
Note: The exhaust air must not be conveyed into a
functioning smoke or exhaust gas flue or into a shaft
which is used to ventilate installation rooms which
contain heat-producing appliances.
▯
Before conveying the exhaust air into a non-
functioning smoke or exhaust gas flue, obtain the
consent of the heating engineer responsible.
▯
If the exhaust air is conveyed through the outer wall,
a telescopic wall box should be used.
Circulating-air mode
The air which is drawn in is cleaned by the
grease filters and an activated carbon filter
and conveyed back into the kitchen.
Note: To bind odours in circulating-air mode, you must
install an activated carbon filter. The different options
for operating the appliance in circulating-air mode can
be found in the brochure. Alternatively, ask your dealer.
The required accessories are available from specialist
outlets, from customer service or from the Online Shop.
The accessory numbers can be found at the end of the
instructions for use.
18

Operation

Note: Switch on the extractor hood when you start
cooking and switch it off again several minutes after you
have finished cooking. This is the most effective way of
removing the kitchen fumes.

Operating the appliance

Control panel
Explanation
#
Fan on/off
1 Fan speed 1
2 Fan speed 2
3 Fan speed 3
Ž

Intensive setting

<
Automatic mode
œ
Saturation indicator
c
Light on/off/dimming

Setting the fan

Switching on
ÿ
▯
Press the button.
The fan starts at setting 2.
▯
Press the 1, 2, 3 or
level of the fan.
Switching off
#
Press the button.
Intensive setting
You can use the intensive setting if there is a large build-
up of odours and fumes/vapours.
ÿ
1 Press the button.
The fan starts at setting 2.
Ž
2 Press the button.
The intensive setting is activated.
Note: The intensive setting is a time-limited
maximum setting which can be activated at any fan
setting and in automatic mode. After approx. 6
minutes, the fan resets to the previously selected
fan setting.
3 To end the intensive setting early, press the
button or the button for another fan setting.
Ž
button to change the power
ÿ