Initial Use; Initial Use With Batteries; Initial Use With Mains Part; Use - Beurer FM 150 Mode D'emploi

5. Initial use

• Remove the packaging.
• Remove the blue protection on the hook-and-loop fasteners of the leg cufs.
• Check the device, mains part and cable for damage.
• You can either operate the device with batteries (4 x 1.5V AA alkaline type LR06) or using the supplied mains part.

5.1 Initial use with batteries

1. Open the battery compartment on the rear of the hand switch.
2. Insert four 1.5V AA (alkaline type LR06) batteries. Make sure that the batteries are inserted the correct way
round. See the graphic in the battery compartment. Do not use rechargeable batteries.
3. Close the battery compartment on the rear of the hand switch until you see and hear it click into place.

5.2 Initial use with mains part

Note
Before using for the irst time with the mains part, check there are no batteries itted in the hand switch.
1. Connect the mains part to the hand switch as shown.
2. Plug the other end of the mains part into a suitable socket.
3. The device is now ready for use.

6. Use

6.1 Starting treatment

IMPORTANT:
• Avoid undoing the leg cuf hook-and-loop fasteners during use as this could impair the functionality of the
device. Only open the leg cuf hook-and-loop fasteners if the pressure on your legs becomes uncomfortable
during use or press the stop button.
• Make sure the air hoses do not become kinked during use.
• Do not cover the leg cufs with a blanket or other objects during use.
1. Always follow the instructions in the "Initial use" section.
18