Panasonic WV-CZ352 Mode D'emploi page 9

MAJOR OPERATING CONSTRUCTION AND THEIR FUNCTIONS
1 Camera Mounting Adapter
Mounts the camera onto a mounting
bracket.
2 DC Input Terminal
Supply 12 V DC from an external power
source.
3 Power Indicator (POWER)
4 Set Button((SET) AF/MENU)
Activates an item selected in the SETUP
menu.
This button is used to activate the Auto
Focus function.
5 Left Button((LEFT) NEAR)
Moves the cursor to the left, selects the
mode and adjusts some levels.
Moves the focus to NEAR.
6 Up Button((UP) TELE)
Moves the cursor upward and selects
items.
Moves the zoom to TELE.
7 Right Button((RIGHT) FAR)
Moves the cursor to the right, selects the
mode and adjusts some levels.
Moves the focus to FAR.
8 Down Button((DOWN) WIDE)
Moves the cursor downward and selects
items.
1
9 Video Output Connector
0 Lens Control Terminal
- Alarm Output Terminal (ALM OUT)
= Day/Night Input Terminal (D/N IN)
~ A/D Control Input Terminal (A/D IN)
! RS485 Data In/Output Terminal
@ RS485 2Wire/4Wire-Term Select
3
2
1
5
4
Moves the ZOOM to WIDE.
Connects the VIDEO IN connector of the
monitor.
Controls the Zoom, Focus and Iris of the
lens.
Connects to the alarm input connector
(terminal) of an external device. When
the camera detects motion, the alarm
output signal is supplied to the connected
external device(Open collector output: 16
V DC, 100 mA max).
This terminal is used for connecting the
camera to an external day/night detecting
sensor.
Controls the camera by the voltage.
These terminals are used for RS485 site
communication. Connect RS485 cables
to these terminals.
Switch
Terminates of the RS485 and selects
either half duplex or full duplex.
9
0
-
=
~
!
@
6
7
8
9