Publicité
Les langues disponibles
Les langues disponibles
5 Electronic Sensitivity Enhancement (SENS UP)
The electronic sensitivity enhancement mode changes as follows:
While the SENS UP function is selected, noise or spots may appear in the picture when
●
the sensitivity of the camera is increased. This is a normal phenomenon.
6 Synchronization Setting (SYNC)
The priorities of SYNC modes are assigned as follows:
1. Multiplexed vertical drive (VD2)
2. Internal sync (INT)
Note: Whenever the vertical drive pulse (VD2) is supplied to the camera, the camera sync
mode is automatically switched to the multiplexed vertical drive pulse (VD2) regard-
less of the selected sync mode.
7 White Balance Setting (WHITE BAL)
1. Auto-Tracing White Balance Mode (ATW1/ ATW2)
The range of colour temperature is
* ATW2 is suited to setting when a sodium lamp is used.
(1) The white balance of the camera is automatically adjusted at ATW1 and ATW2.
(2) For fine adjustment of ATW1/ATW2, press the SET button. The ATW1/ATW2 fine
adjustment menu appears on the monitor screen.
2. Automatic White Balance Control Mode (AWC)
(1) Select AWC n PUSH SET.
(2) Press the SET button to start the white balance setup. PUSH SET is highlighted to
indicate that white balance is being set.
(3) PUSH SET returns to normal when balance setting is completed.
(4) For fine adjustment of the AWC, move the cursor to AWC and press the SET button.
The AWC fine adjustment menu appears on the monitor screen.
18
OFF
X2 AUTO
X4 AUTO
X16 AUTO
X32 AUTO
X6 FIX
X10 FIX
X16 FIX
ATW1 2 600 K-6 000 K
ATW2 2 000 K-6 000 K
** ATW1 **
R
B
RET TOP END
**
R
B
RET TOP END
X6 AUTO
X10 AUTO
OFF
X2 FIX
X4 FIX
X32 FIX
••••|••••
-
+
••••|••••
-
+
AWC
**
••••|••••
-
+
••••|••••
-
+
Publicité
