Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2
fig.40
1
2
fig.41
1
2
fig.42
OPERATION
BEVEL CROSSCUTTING 0
This cutting operating is the same as crosscutting, except that the blade is at a
bevel angle other than 0
1
the right side groove.
• Adjust the blade (1) to the desired angle, and then tighten the blade bevel lock
knob.
• Tighten the mitre lock handle (3) at 90
• Hold the workpiece (2) firmly against the face of the mitre gauge throughout the
cutting operation.
WARNING! Always work to the right side of the blade during this type of cut. The
mitre gauge must be in the right side groove, because the bevel angle may cause
the blade guard to interfere with the cut if it is used in the left side groove.
0
~45
BLADE BEVEL & 0
O
O
This sawing operation combines a mitre angle with a bevel angle. This operation
must be performed with the mitre gauge in the right side groove.
• Set the mitre gauge (3) to the desired angle.
• Place the mitre gauge in the right side groove of the table.
• Set the blade (1) bevel to the desired bevel angle, and tighten the blade bevel
lock knob.
• Hold the workpiece (2) firmly against the face of the mitre gauge throughout the
cutting operation.
WARNING: Always work to the right side of the blade during this type of cut. The
mitre gauge must be in the right side groove, because the bevel angle may cause
3
the blade guard to interfere with the cut if it is used in the left side groove.
MITERING 0
~45
o
This sawing operation is the same as crosscutting, except that the mitre gauge is
locked at an angle other than 90
• Set the blade (1) to the 0
knob.
• Set the mitre gauge (3) to the desired mitre angle, and lock it in position by
tightening the mitre gauge locking handle.
• Hold the workpiece (2) firmly against the face of the mitre gauge throughout the
cutting operation.
3
~45
BLADE BEVEL & 90
o
o
o
. This operation must be performed with mitre gauge in
.
o
~45
MITRE ANGLE (FIG.41)
O
O
MITRE ANGLE (FIG. 42)
o
.
o
bevel angle, and then tighten the blade bevel lock
o
MITRE ANGLE (FIG. 40)
O
51
Publicité
Chapitres
Table des Matières
Dépannage
