Haussmann MJ10250IX Guide De L'utilisateur page 48

90
1
3
fig.29
1
fig.30
1
fig.31
Pointer
fig.32
ASSEMBLY AND ADJUSTMENTS
ADJUSTING THE MITRE GAUGE (FIG.29)
• Loosen the lock handle (1) in order to allow the mitre body (2) to rotate freely.
Position the mitre body at 90
o
Tighten the lock handle in order to hold the mitre body in position.
• If the pointer (3) requires adjustment, loosen the two screws under the pointer
using a hex wrench. Adjust the pointer to 90
tighten both adjusting screws.
• To change angles on the mitre gauge, loosen the lock handle (1) and rotate the
2
mitre body to the desire angle, as indicated by the scale. Secure in position by
tightening the lock handle.
ADJUSTING THE 90
This saw has positive stops that will quickly position the saw blade at 90
table. Make adjustments only if necessary.
90 STOP (FIG. 30)
O
• Raise the blade to the maximum height by turning the control handle counter
-clockwise.
• Loosen the bevel angle locking knob.
• Tilt the blade to the 90
• Using a square (1), verify that the blade is at a 90
• If blade is not at a 90
• Loosen the bevel locking knob and square the blade 90
2
• Once the blade is at a 90
locking knob.
• Carefully tighten the adjusting screw (2) until it touches the bevel stop.
DO NOT OVERTIGHTEN.
• Verify that the blade is still aligned at 90
45 STOP (FIG. 31)
O
• Raise the blade to the maximum height by turning the control handle
counter-clockwise.
• Loosen the bevel angle locking knob.
• Tilt the blade to the 45
• Using a square (1), verify that the blade is at a 45
2
• If blade is not at a 45
• Loosen the bevel locking knob and set the blade at a 45
• Once the blade is at a 45
knob.
• Carefully tighten the adjusting screw (2) until it touches the bevel stop.
DO NOT OVERTIGHTEN.
• Verify that the blade is still aligned at 45
BLADE TILT POINTER (FIG. 32)
• When the blade is positioned at 90
scale.
• Loosen the holding screw, position the pointer over the 0
NOTE: Make a trial cut on a scrap piece of wood before making critical cuts.
Measure for exactness.
CAUTION: TO PREVENT PERSONAL INJURY:
a. ALWAYS DISCONNECT THE PLUG FROM THE POWER SOURCE WHEN
MAKING ANY ADJUSTMENTS.
b. THIS ADJUSTMENT MUST BE CORRECT, OR KICKBACK COULD RESULT
IN A SERIOUS INJURY AND INABILITY TO MAKE ACCURATE CUTS.
o , so that the positive detent secures its position.
AND 45 POSITIVE STOPS (FIG. 30-31)
O O
o (0 o ) bevel.
(0 ) angle to the table, loosen the adjustment screw (2).
o o
(0 ) angle to the table top, tighten the bevel angle
o o
(0 ).
o o
bevel.
o
angle to the table, loosen the adjustment screw (2).
o
o angle to the table top, tighten the bevel angle locking
.
o
, adjust the blade tilt pointer read 0
o
on the scale, and then firmly
o
o
(0 ) angle to the table top.
o o
(0 ) to the table.
o o
angle to the table top.
o
angle to the table.
o
on the
o
o , and tighten the screw.
to the
47