Haussmann MJ10250IX Guide De L'utilisateur page 47

ASSEMBLY AND ADJUSTMENTS
INSTALLING THE REAR TABLE EXTENSION (FIG.25)
• Insert the rear table extension tube (1) into the two holes in the rear of the saw
table, and into the extension tube brackets that are located under the table.
Position the rear table support so the instruction labels are facing up.
• Tighten one extension wing stop screw (3) on the end of the left rear table extension
tubes (1). Verify that the screw is fully inserted into the corresponding holes (2)
in the extension tube.
ADJUSTING THE REAR TABLE EXTENSION
• When ripping a short workpiece, the rear extension table should be positioned
as close to the rear of the main table as possible.
• When ripping a long workpiece that requires extra support as the cut is completed,
the rear extension table should be pulled out as far as possible, until the locating
seat prevents it from moving out any further.
CAUTION: PIECES OVER 24" (0.6 M) SHOULD HAVE TWO PERSONS OR
ROLLER TO ACCEPT THE CUT PIECES.
INSTALLING AND USING THE RIP FENCE (FIG.26-27)
• The rip fence can be used on either side of the saw blade.
• The fence (1) is moved by lifting the handle (2) and sliding the fence to the
desired location. Pushing down on the handle locks the fence in place.
• Position the fence on the right side of the table, along the edge of the mitre gauge
groove.
• Lock the fence handle. The fence should be parallel with the mitre gauge groove.
• If adjustment is needed in order to make the fence parallel to the groove, follow
these step:
• Loosen the two bolts (3), and lift the handle (2).
• Hold the fence bracket (4) firmly against the front of the saw blade. Move the
far end of the fence until it is parallel with the mitre gauge groove.
• Push the handle down to lock it, and tighten both screws.
• If fence is loose when handle is in the lock (down) position, follow these steps:
• Lift the handle (2) and turn the adjusting nut (5) clockwise until the rear clamp
is snug. Do not turn the adjusting screw more than 1/4 turn at a time.
• Over-tightening the adjusting screw could bend the rear clamping lever, which
may cause the fence to come out of alignment.
ADJUSTING THE RIP FENCE INDICATOR (FIG.28)
• The rip fence indicator (6) points to the measurement scale (8). The scale shows
the distance from the side of the fence closest to blade.
• Measure the actual distance with a ruler. If there is a difference between
the measurement and the indicator, adjust the indicator (6).
• Loosen the screw (7), and slide the indicator to the correct measurement on the
scale. Tighten the screw, and re-measure with ruler.
46
1
3
fig.25
fig.26
5
fig.27
6
8
7
fig.28
2
1
3
4
2