Haussmann MJ10250IX Guide De L'utilisateur page 41

ASSEMBLY AND ADJUSTMENTS
beginning cutting.
WARNING: The laser beam is emitted when the laser line is turned on. Do not
stare into the beam or view it directly using optical instruments. Do not remove
the warning label that is affixed to the laser cover. Avoid aiming the laser beam
directly into the eyes. Caution-use of controls or adjustments or performance
of procedures other than those specified herein may result in hazardous
radiation exposure.
CAUTION: The use of optical instruments with this product will increase eye
hazard.
Maximum output: <1 mW Wavelength: 650 nm Protection Class: II
NOTE:
a. A laser beam is not a toy, and it should not be used by children. Misuse of
the laser line can lead to irreparable eye damage.
b. It is strongly advised that you use laser protective eyewear for the specific
wavelength of emitted light when working on or near reflective surfaces.
c. Do not perform any adjustments that are intended to increase the power of
the laser.
d. When using the laser line, do not point the laser beam at people and/or
reflecting surfaces. Even a low-intensity laser beam can cause eye damage.
Do not look directly into the laser beam.
e. If the laser line will not be used for more than three months, remove the
batteries in order to avoid damage from possible leakage.
f. The laser line does not include any user-serviceable components. Do not
open the housing in an attempt to repair it.
g. Repairs should only be carried out at a service centre or by an authorized
service technician.
WARNING: DO NOT CONNECT THE PLUG TO THE OUTLET UNTIL ALL
INSTALLATIONS AND ADJUSTMENTS HAVE BEEN COMPLETED AND YOU
HAVE READ AND UNDERSTOOD THE SAFETY AND OPERATIONAL
INSTRUCTIONS.
ASSEMBLE THE STAND (Fig. 2-6)
1. Unpack all parts, and group them by type and size. Refer to the parts list for
correct quantities. (see Fig. 2)
2. Attach one long top leg bracket to the top of one leg using a bolt, flat washer,
spring washer and hex nut. (see Fig. 3)
NOTE: Do not tighten the bolts until the stand is properly aligned (see step #8).
3. Attach other end of the long top leg bracket to top of another leg using using a bolt,
flat washer, spring washer and hex nut.
4. Attach one long bottom leg bracket to the centre of each leg using a bolt, flat washer,
spring washer and hex nut. This completes the front frame section. (see Fig. 4)
5. Assemble the rear frame section in exactly the same manner.
6. Join the front and rear frame assemblies to the two short upper supports and two
short bottom supports using a bolt, flat washer, spring washer and hex nut.
(see Fig. 5)
40
ATTENTION/CAUTION
!
RAYONNEMENT LASER. NE REGARDEZ PAS
DIRECTMENT LE FAISCEAU.
LASER RADIATION. DO NOT STARE INTO BEAM.
Longueur d'onde / Wavelength: 650 nm
Puissance maximale / Max. Output: 1 mW
Produit laser de classe II
Class II Laser Product
Conforme au règlement 21 CFR sections 1040.10e
Complies with 21 CFR 1040.10e
A B C
Hex nut Flat washer Bolt M6x14 Sping washer Rubber foot
fig.2
A
fig.3
A
fig.4
B
E
A
C
D
B
A
C
fig.5
D E
B
A
E
A
D
A