Messages - Teac Tascam 16 Mode D'emploi

12

- Messages

The following is a list of messages that appear in pop-up windows.
Refer to this list if one of these pop-up messages appears on the
response.
Message Meaning and response
The SD card cannot be recognized properly. Replace the SD card.
Card Error
The SD card has no remaining capacity. Erase unnecessary files or transfer them to a computer.
Card Full
A file with the same name already exists. Change the file name.
Dup File Name
The file cannot be found or the file may be damaged. Check the relevant file.
File Not Found
The system file is missing. This unit requires a system file for operation.
No sys file
When this message appears, press the MULTI JOG dial to create a system file.
Make sys file
This operation is not possible because the song is protected. Remove protection.
Song Protected
Invalid Card
Something might be wrong with the SD card. Change the SD card.
Change Card
The time between the punch in and out points is too short. Set them with at least 1 second between
I/O Too Short
them.
The SD card is not formatted properly or the card is broken.
MBR error
Change the SD card or press the MULTI JOG dial while this message is being shown to format the card.
Init card
Formatting will erase all the data on the SD card.
A SD card is not set.
No Card
Insert a recordable SD card.
The file format is not supported. Please see "Playing WAV files on SD cards (SD PLAY mode)" on page 48
Non-supported
for file formats that this unit can use.
The SD card is write-protected. Disable SD card write-protection.
Card Protected
The sampling rate of the current song and the USB audio interface are not the same.
USB Fs mismatch
Change the sampling rate of one so that they are the same.
The current song cannot be deleted. To delete the current song, load another song first.
Current Song
The punch in/out point settings on the AUTO PUNCH Screen are not set correctly.
Automatic punching in/out occurred at an invalid position for the punch in or out point.
Invalid I/O point
Start the automatic punch operation from a valid point.
Write error
Writing to the SD card timed out. This has caused audio to be interrupted and noise to occur.
REC continue
Writing to the SD card timed out, and recording stopped.
REC stop
SD card writing performance has become worse.
Card slow
Execute the erase format function or change the SD card.
Neither the punch in or out points are set for the automatic punch in/out function.
Need to set
Either the punch in or out point must be set.
I/O point.
The sampling frequency of the WAV file to be imported does not match the current song.
Sample rate
Select a WAV file with the same sampling frequency as the current song or convert the sampling
Unmatch
frequency before importing.
The SD card does not have enough open space, so importing is not possible.
Remain time is
Erase unnecessary files or transfer them to a computer.
not enough
The maximum number of tracks for punch in recording is eight.
8 track
Press REC buttons to reduce the number of recording tracks to eight or less.
punch in limit
No song is loaded.
Song is not
Create a new song or load a song.
loaded
The maximum number of songs that can be created on an SD card is 100.
Song number full
Erase unnecessary songs.
SD PLAY mode is for playback only.
SD PLAY:
Recording is not possible.
cannot record
Recording is not possible because the SD card cluster size is not right.
SD CARD cluster
Back up the contents of the SD card on a computer and then format it with this unit.
size error
Then, restore the data from the computer.
Importing is not possible because there are no open tracks.
Import error.
Use TRACK CLEAR to clear a track. (See "Clearing tracks" on page 43)
No track
The selected song is already protected.
Already protected
The selected song is already unprotected.
Already unprotected
56
TASCAM Model 16
Model 16 and you want to check the meaning or determine a proper