Notification Function; Setting Sound Properties; Simultaneous Asio/Wdm Playback - Teac Tascam 16 Mode D'emploi

Notification function

If the computer you are using is connected to the Internet,
the latest information about unit firmware and software, for
example, can be shown when the Settings Panel is launched.
NOTE
Put a check in the "Do not show the same message again"
checkbox to prevent the same message from being shown
the next time it is launched.

Setting Sound Properties

1. Open the OS Control Panel.
NOTE
Follow these procedures to open the Control Panel.
Windows 10
Left-click the Windows Start button, and from Windows
System select Control Panel.
Windows 8.1
Right-click the Windows Start button, and select Control
Panel.
Windows 7
Left-click the Windows Start button, and select Control
Panel in the Start menu.
2. Double-click Sound in the Control Panel.
NOTE
If the Control Panel is set to be viewed as icons, a Sound icon
will appear.
3. On the Playback page, right-click
Default Device in the pop-up menu that appears.
When you do this, the green check mark appears next to
the selected device.
Windows 7 screen
NOTE
Set the default device according to the ASIO device being
used on the Recording tab in the same manner as on the
11 - USB audio interface functions
Model 16, and click Set as
Playback tab.
4.
After completing the setting, click the OK button.
5.
Launch Windows Media Player and start playback to input
the playback sound from the computer to channels 1 and 2
16. (MODE switches: PC)
on the Model
NOTE
i If you change the setting while Windows Media Player is
running, the software will not recognize that the device has
been changed. In this case, restart Windows Media Player.
i If you still cannot hear sound after making the settings and
completing the procedures above, restart the computer.
i If you make this setting, sound will be output through this
unit, but no sound will be output from the computer's
speakers or headphone jack.

Simultaneous ASIO/WDM playback

The driver for this unit can simultaneously play ASIO output
from a DAW and WDM output from Windows Media Player, for
example. The sample rates of both sources must be set to the
same value for simultaneous playback to be possible. Moreover,
the sample rate must also be set to the same value for both
playback and recording in the Windows Sound Properties.
When the sample rates are the same
Example: Windows (WDM) at 44100 Hz, ASIO at 44100 Hz
The Windows audio and ASIO sound are mixed and played
simultaneously.
When the sample rates are different
Example: Windows (WDM) at 48000 Hz, ASIO at 44100 Hz
Only sound from a DAW and other ASIO sources are output.
Sound from Windows Media Player and other WDM sources
are not output.
When the DAW is shut down, for example, and output from
ASIO sources stops, sound from Windows Media Player and
other WDM sources will become audible.
55
TASCAM Model 16