Undoing Operations; Undoing The Previous Operation; Using The Built-In Effects; Setting The Built-In Effect - Teac Tascam 16 Mode D'emploi

5 - Basic recording

Undoing operations

If you make a mistake operating the unit or want to do a
recording over, for example,the operation last conducted can be
undone. Editing, recording and other operations can be undone.
The following types of operations can be undone.
p Recording operations
p Auto punch in/out operations
p Track clearing operations
If a song is loaded or the unit is turned off, Information used
for undoing and redoing will be lost, so undoing and redoing
previous operations will no longer be possible.
NOTE
Files used for undoing are temporarily saved on the SD card.
If you want to delete those files to make more space on the
SD card, reload the current song on the SONG Screen.

Undoing the previous operation

1. When the Home Screen is open, press the F3
The following confirmation pop-up message will appear.
2. Press the F4
button to return to the state before the
previous operation.
NOTE
To cancel undoing, press the F1
Redoing an undone operation
1.
After undoing, when the "
Screen, press the F3
The following confirmation pop-up message will appear.
2. Press the F4 button to restore the previous operation
and return to the state before undoing.
NOTE
To cancel redoing, press the F1
38
TASCAM Model 16
button.
button.
" appears on the Home
button.
button.

Using the built-in effects

This unit has built in effects, so you can apply effects without an
external effect device.
1-8 9/10-11/12
Channels and
signals are sent to the built-in effect by the FX bus.
The return signal is returned to the MAIN MIX L/R and MONITOR
OUT 1/2 buses.
1. Use the FX knobs of each channel to adjust the levels of
signals sent to the FX bus.
2.
Use the EFFECT Screen to select the type of effect. (See
"Setting the built-in effect" on page 38)
3. Use the FX fader and TO MON 1/TO MON 2 knobs to adjust
the return levels for the MAIN MIX L/R and MONITOR OUT
1/2 buses.
4. When the AFL switch is on (pushed in), use the
PHONES knob to adjust the return level.
NOTE
The sound with the effect applied can be monitored from the
CONTROL ROOM L/R jacks or PHONES jack.

Setting the built-in effect

1. Press the SELECT button to open the EFFECT Screen.
2. Turn the MULTI JOG dial, and set the built in effect type.
Options: 1.SMALL HALL (default), 2.LARGE HALL,
3.SMALL ROOM, 4.LARGE ROOM,
5.PLATE, 6.STUDIO,
7.LIVE, 8.SHORT DELAY,
9.DELAY, 10.PING PONG,
11.CHORUS, 12.FLANGER,
13.DELAY+SHALL, 14.DELAY+LHALL,
15.CHORUS+SHALL, 16.CHORUS+LHALL
3. Press the MULTI JOG dial to select the PARAMETER item.
4. Turn the MULTI JOG, and adjust the set effect.
You can check the effect as you change it.
NOTE
i Press the F2 button to show the unit for the currently
selected effect. The effect itself is the same regardless of
whether the PARAMETER or the unit are shown.
i Press the F4 button to set the PARAMETER value for the
currently selected TYPE to its default.
can have an effect applied. Their
CR
fader/