Analog Output Adjustment Section; Rear Panel - Teac Tascam 16 Mode D'emploi

Analog output adjustment section

MUTE switch and indicator (FX)
U
MUTE switch are on (pushed in, MUTE
When the
lit), the signal from the built-in effect is muted.
I FX fader
Use to adjust the levels of signals sent from the built-in effect
to the following buses.
i MAIN MIX L/R bus
i PFL/AFL L/R bus
i MONITOR OUT 1/2 buses
i SUB L/R bus
O MON switch (FX)
When this switch is on, signals from the built-in effect are
sent to the MONITOR OUT 1/2 buses.
MAIN switch (FX)
P
When this switch is on, signals from the built-in effect are
sent to the MAIN MIX L/R bus.

Rear panel

USB port
L
This is a B-type USB port. Use a USB cable (Type-A to Type-B)
to connect the unit to a computer. (See "Connecting with a
Computer" on page 49)
ATTENTION
The unit should be connected directly to the computer, not
through a USB hub. Moreover, noise could be picked up if the
cable is too long.
AC IN connector
:
Connect the included power cord here.
2 - Names and Functions of Parts
A SUB switch (FX)
When this switch is on, signals from the built-in effect are
sent to the SUB L/R bus.
S AFL switch (FX)
When this switch is on, signals from the built-in effect are
sent to the PFL/AFL L/R bus.
D POST REC
Select the send position of the signal recorded to the SD
card.
When this switch is on, signals from after the MAIN fader are
recorded to the SD card.
indicator
MUTE switches and indicators
F
When MUTE switches are on (MUTE indicators lit), signals to
the SUB OUTPUT/MAIN OUTPUT jacks are muted.
G CR fader
Use to adjust the output levels of the CONTROL ROOM L/R
jacks.
SUB fader
H
Use to adjust the output level of the SUB OUTPUT jacks.
MAIN switch (SUB)
J
When this switch is on (pushed in), the SUB OUTPUT L/R jack
output signal is sent to the MAIN MIX L/R bus.
MAIN fader
K
Use to adjust the output level of the MAIN OUTPUT jacks.
POWER switch
Z
Press to turn the unit on and off.
V CAUTION
Before turning the unit on, lower the volumes of connected
equipment to their minimum levels.
Failure to do so might cause sudden loud noises, which could
harm your hearing or result in other trouble.
NOTE
Do not do this when the unit is operating (including
recording, playing back or writing data to an SD card). Doing
so could cause proper recording to fail and recorded data to
be lost.
switch
(SUB,
TASCAM
MAIN)
25
Model 16