TSM GRANDE BRIO 45 E Manuel D'opération page 23

GRANDE BRIO 45, 50 & 55
OPERATING MANUAL
6 OPERATION
6.1 Preparing to work
BATTERY (B) & CABLE (E) VERSION WITHOUT TRACTION
1. Prepare the machine for operation
2. Press brush switch (Fig. 8-4)
3. Press vacuum switch (Fig. 8-1)
4. Lower the squeegee
5. Press the start switch of brush motor on the handle (Fig. 7-5)
BATTERY VERSION WITH TRACTION (BT)
Traction is due to a differential motor unit. A potentioemeter and a button (Fig 8-5 & 8-4) adjust speed and direction.
1. Prepare the machine for operation
2. Press brush switch (Fig. 8-4)
3. Press vacuum switch (Fig. 8-1)
4. Lower the squeegee
5. Press the start switch of brush motor on the handle (Fig. 7-5)
6. Adjust the feed rate by turning the potentiometer (Fig. 8-5).
WARNING
- Before starting the machine, check all the controls and safety devices to use it in the most
appropriate way. Avoid climbing over objects, holes along the course.
Do not put your hands, feet or any other object near the moving brush.
When the battery charge level is about to run out, the minimum calibration voltage appears on the display and the
first segment of the LED bar flashes and the brush and vacuum motors switch off automatically; it is therefore
necessary to recharge the machine as soon as possible.
To bring the machine to the recharging point, it is necessary to lift the front of the machine and remain resting on
the transport wheels.
If there are any problems while working, turn off the key, disconnect the battery connector promptly. These
commands will block every moving part of the machine. To resume operations, once the problem is resolved,
reconnect the connector and turn on the key.
When making reverse movements, even if short, lift the squeegee.
Do not move the machine too fast.
6.2 Recovery tank full
The machine has a filter and a float that stop the aspiration motor whenever the recuperation tank is full. It causes the
closure of the vacuum hose. In this case it's required to empty the tank.
6.3 Traction
The machine traction is obteined by the brush/es, that working slightly inclinated, move the machine ahead.
The BT versions have an electronically controlled traction system. To move the machine, firstly turn on the key and press the
brush switch on the right handle. Regulate the speed by the knob for speed regulation; if this is set to minimum, machine will not
move.
WARNING
- To avoid wear of the squeegee blades or any damage to the squeegee, reverse gear must be carried
out with the squeegee lifted off the ground.
7 AFTER WORK IS TERMINATED
WARNING
- These operations must be carried out with the machine switched off, using gloves to protect
hands and making sure there are no objects or people nearby.
7.1 Battery version (BT, BT)
At the end of the work, before performing any type of maintenance proceed as follows
1. Turn off vacuum motor switch (Fig 8-1)