Lenze 8200 motec Instructions De Montage page 47

Masquer les pouces Voir aussi pour 8200 motec:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Mounting
1. Mount the housing shell to the mounting plate using the 2 self-tapping screws
5 × 18.
2. Mount the cable glands M16 using a 10 mm thread length.
3. Screw the fixing frame for the fieldbus function module into the housing shell using
2 self-tapping screws 3 × 10.
4. Press the fieldbus function module into the fixing frame until it snaps into place.
5. Remove the cover of the terminal strip.
6. Wire the fieldbus function module.
– Remove approx. 10 cm of the cable sheath.
– Connect the shield to the shield sheet using the cable tie.
– Wire the fieldbus function module (see corresponding Mounting Instructions).
Terminal 28 (controller inhibit) of the fieldbus function module  is inactive. Controller
is inhibited via terminal 28 of the bus-I/O function module.
7. Mount motec carrier housing
– Break out holes at the predetermined breaking points .
– Insert 2 screws M5 × 20 through holes  and 2 self-tapping screws 5 × 55 through
holes .
– Screw motec carrier housing onto the housing shell.
EDK82ZMFBC-001 DE/EN/FR 7.0
Mechanical installation
Wall mounting
E82ZMFB006
4
47

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

E82zmfbc001

Table des Matières