Oceanic BC Mode D'emploi page 14

AttachingtheQuickDisconnect(QD)InflatorHose
• With the QD Inflator Hose attached to your regulator, connect the regulator system to a
pressurized tank making sure the regulator system is purged of air.
• Grasp the free end of the QD inflator hose between the palm of your hand and fingers, then pull
back the coupling release with your thumb and forefinger.
• While holding back the coupling release, press it onto the inlet fitting on the power inflator.
• Let go of the coupling release while continuing to hold the QD Inflator Hose onto the inlet fitting.
• Ensure that the QD Inflator Hose is securely attached and pressurize the regulator system by
slowly opening the tank valve.
• Press the power inflator button until you hear air flowing into the BC.
• Minor compressions of the inflator button will initiate airflow into the BC and allow small
adjustments in buoyancy.
  W ARNING:IfyoudepressthePowerInflatorbuttonfully,theBCwillinflaterapidly.Be
carefulnottooverinflatetheBCcausinganunwantedrapidrisetowardsthesurface.
Test the Power Inflator and OPV prior to each dive to ensure they are functioning properly.
• Depress the Power Inflator until the BC fills completely, forcing the shoulder mounted Over
Pressure Relief Valve open. You will hear the sound of air venting from valve, indicating that the
valve is working properly.
• While the BC is still inflated, listen for any undesired air leakage around the lower inflator or
Quick Release coupler. The BC should stay inflated until you deflate it manually.
14