Clean-Up After Installation - Kohler RiverBath K-1360 Guide D'installation

Ï Ï Ï Ï
Ï Ï Ï Ï
Ï Ï Ï Ï
Ï Ï Ï Ï
Apply silicone
sealant to the joint
between the
finished wall and
the whirlpool rim
10. Complete the Finished Wall - Continued
Tiled Ledge Installation
- If you have not already done so, carefully remove the protective tape from the whirlpool rim.
- Cover the framing with water resistant wall material.
- Tape and mud the water resistant wall material. Install the finished wall to the water resistant wall material. Seal
the joints between the whirlpool rim and the finished wall material with silicone sealant.
NOTE: The exposed area of the whirlpool rim must not be less than 37 5/8" (95.6cm) x 72" (182.9cm) in order for
the pillows to fit properly.
- Install the faucet trim according to the instructions packed with the trim.
- Install the grip rails according to the installation instructions packed with the grip rails.

11. Clean-Up After Installation

- When cleaning up after installation, do not use abrasive cleansers, as they may scratch and dull the whirlpool
surface. Use warm water and a liquid detergent to clean the surface.
- Remove stubborn stains, paint, or tar with turpentine or paint thinner. Do not allow cleaners containing
petroleum distillates to remain in contact with any whirlpool surfaces for long periods of time. Remove plaster
by carefully scraping with a wood edge. Do not use metal scrapers, wire brushes, or other metal tools. Use a
powder type detergent on a damp cloth to provide mild abrasive action to any residual plaster.
A
1012489-2-
Install the finished
ledge material
First install
water-resistant
wall material
Ï Ï
Framing
Ï
Ï
Ï
Whirlpool Flange
First install
Ô Ô Ô Ô Ô
water-resistant
Ô Ô Ô Ô Ô
wall material
Ô Ô Ô Ô Ô
Ô Ô Ô Ô Ô
Ô Ô Ô Ô Ô
Install the
finished wall
Ô Ô Ô Ô Ô
material
Ô Ô Ô Ô Ô
Apply silicone
sealant to the joint
between the
finished wall and
the whirlpool rim
10
Ô
Finished
Ledge
Kohler Co.