Kohler RiverBath K-1360 Guide D'installation page 13

Press the
"River/Whitewater/Rapids"
button to control the
whirlpool functions
Press the
"Tidewater" button
to turn on and off
the air supply to
the jets
13. Confirm Proper Operation - Continued
Operating Sequence
NOTE: A built in heater automatically maintains the water temperature when the whirlpool is running.
NOTE: Your RiverBath uses two pumps. One pump powers the Waterfall, and the second pump propels water
through the whirlpool jets and River Jets.
NOTE: The River Jets will only operate if both water level sensors are completely covered with water. If the water
level drops below the sensors, the River Jets will automatically turn off, and the whirlpool jets will turn on.
NOTE: The River Jets and whirlpool jets will not operate at the same time. The Waterfall, however, will run in
conjunction with either the River Jets or the whirlpool jets.
- To use the Waterfall: Press the Waterfall" control button once. The Waterfall will start to flow at maximum
volume within several seconds. Adjust the water flow volume by pressing and holding down the volume control
arrows in the direction desired. Press the Waterfall" control button a second time to turn off the Waterfall.
- To use the jets: Press the River/Whitewater/Rapids" control button to start the whirlpool jet functions. The
eight whirlpool jets will start to flow at high volume immediately. Adjust the water flow volume by pressing the
holding down the volume control arrows in the direction desired.
- Your whirlpool jet system adds air to the water stream to increase the force of the water flow. Decrease the force of
the whirlpool water flow by turning the whirlpool trim rings clockwise until you obtain the desired water force.
Turn the trim rings counterclockwise to increase the water flow force.
- Press the River/Whitewater/Rapids" control button again to turn off the whirlpool jets and turn on all four
River Jets. Water will flow from the River Jets within several seconds.
- Press the River/Whitewater/Rapids" control button a third time to turn off the two center River Jets. The two
outermost River Jets will continue to run.
- Press the Tidewater" control button anytime the whirlpool is running to turn off the air supply to the jets. Press
this control button a second time to toggle the air supply on again.
NOTE: Some air may continue to flow from one or more jets for a short time after the air supply has been turned
off with the Tidewater" control.
- Press the River/Whitewater/Rapids" control button a fourth time to turn off the pump.
NOTE: A built in timer automatically stops the pump and motor after approximately 20 minutes of operation.
Kohler Co.
Use the arrow
keys to adjust the
water flow volume
Press the
Use the arrow
"Waterfall" button
keys to adjust
to control the
the water flow
Waterfall
volume
functions
Turn the jet trim
ring clockwise to
decrease the flow
13
Turn the jet trim ring
counterclockwise to
increase the flow
A
1012489-2-