Publicité
Les langues disponibles
Les langues disponibles
BM 1619P02168 12-07
Disconnect the plug from
!
WARNING
the power source before
making any assembly, adjustments or
changing accessories. Such preventive
safety measures reduce the risk of starting the
tool accidentally.
INSTALLING SDS-plus
Clean the insert shank end of the accessory to
remove any debris, then lightly grease with a
light oil or lubricant
Insert accessory into the chuck through the
dust shield, while twisting and pushing inward
until it locks automatically into place. Pull
outward on the accessory to be certain it is
locked into the chuck (Fig. 2).
FIG. 2
SDS-plus
CHUCK
DUST
SHIELD
OFFSET AUXILIARY HANDLE
The tool must be supported with the auxiliary
handle, which can be swiveled 360˚.
To reposition and/or swivel the handle, loosen
the hand grip, move the handle to the desired
position along the barrel and securely retighten
the hand grip (Fig. 4).
12/5/07
3:52 PM
Assembly
®
ACCESSORIES
®
Page 7
NOTE: The high efficiency available from the
rotary hammers can only be obtained if sharp
and undamaged accessories are used. The
"cost" to maintain sharp and undamaged
accessories is more than offset by the "time
saved" in operating the tool with sharp
accessories.
REMOVING SDS-plus
Accessories may be hot after
!
WARNING
use. Avoid contact with skin
and use proper protective gloves or cloth to
remove.
To remove an accessory, pull locking sleeve
backward and pull bit forward. All accessories
should be wiped clean after removing (Fig. 3).
FIG. 3
LOCKING
SLEEVE
FIG. 4
-7-
®
ACCESSORIES
HAND GRIP
Publicité
