Dentsply Maillefer propex pixi Manuel D'utilisateur page 17

3. During the demo cycle the device operating sequence is shown on the screen.
4. Demo cycles are repeated automatically until interrupted by the operator.
5. To exit the demo mode press the
second until a beep sounds. The device shuts down.
Note: If the measurement cable is connected to propex
cycle, the device switches automatically to normal operation mode.
6.9 Automatic shutdown
propex pixi automatically shuts down after 3 minutes of non-use. In order to prolong
™
•
battery life, it is recommended to switch the device off after usage by pressing the
"ON / OFF" button.
7. MAINTENANCE OF YOUR PROPEX PIXI
7.1 General recommendations
• The device does not contain user serviceable parts. The service and repair should be
provided by factory trained service personnel only.
• After each use, all objects that were in contact with infectious agents should be cleaned
using towels impregnated with a disinfecting and detergent solution (a bactericidal,
fungicidal and aldehyde free solution). Use of chemical agents may cause damage to
the equipment. We recommend to use only a disinfecting solution which is approved
for its efficacy (VAH/DGHM-listing, CE marking, FDA approval).
Pic. 14
"ON / OFF" button and hold for about 1
•
™
17
pixi during the demo
™
•