Dentsply Maillefer propex pixi Manuel D'utilisateur page 158

ELECTROMAGNETIC COMPATIBILITY (EMC)
Changes or modifications to this product not expressly approved by the manufacturer
may result in increased emissions or decreased immunity performance of the product
and could cause EMC issues with this or other equipment. This product is designed
and tested to comply with applicable regulations regarding EMC and shall be installed
and put into service according to the EMC information stated as follows.
WARNING
Use of portable phones or other radio frequency (RF) emitting equipment near the
product may cause unexpected or adverse operation.
WARNING
The product must not be used adjacent to, or stacked with, other equipment. If adja-
cent or stacked use is necessary, the product must be tested to verify normal operation
in the configuration in which it is being used.
Compliant Cables and Accessories
WARNING
The use of accessories, transducers and cables other than those specified may result
in increased emissions or decreased immunity performance of the product.
The table below lists cables, transducers, and other applicable accessories for which
the manufacturer claims EMC compliance.
NOTE: Any supplied accessories that do not affect EMC compliance are not listed.
Description
Measuring Wire
Charger Wire
Lenght. max
0.6m
1.5m
158