Interior Light; Automatic Door Control Led (Adc) Optional - Dometic RH 423LDA Mode D'emploi

8.2. Interior light

Two light-emitting diodes (A) on an electronic PCB
illuminate the cooling compartment when the door is
opened.
Two sensors (B) control whether the door is open or
not and the LEDs and the door control as well will
work accordingly.
B
8.3. Automatic Door Control LED (ADC)
(optional)
Free-standing version:
The LED (Fig. 7.A) mounted to the screw down foot
lower door hinge indicated whether the miniBar door
has been opened. If so then:
1. Open the miniBar, check the content in the
compartement and if necessary, replenish.
2. Reset the door control signal by helding the
Remote control against the door opening sensor
(Fig. 6. B) and push the button .
3. Close the miniBar.
Built-in version:
The LED must be fitted to the door plate on the hinge
side at the upper part.
The LED can be fitted by using the components-kit
(Fig. 8).
A B
1. Fit the cable with the cable bridge (A) to the side
wall on the hinge side by drilling the holes
according to Fig. 9.
(fig. 6.)
A
Figure 6.
A
Figure 7.
C
Figure 8.
mm
mm
2. Drill the hole for the LED according to the
Figures 10 and 11.
1
mm
Place of LED
mm
Side Wall
1
mm
Figure 10.
mm
Figure 11.
Attention!
By mounting the LED cable take care of the correct
distances otherwise the too short cable will not
allow you to open the door fully.
3. Put the LED-holder (B) into the hole from
outside.
4. Mount to insulation (C) with the LED cable and
then, snap it to the LED-holder and fit the cable
(Fig. 12).
Figure 12.
5. Connect the miniBar to the mains. After opening
the door the red LED must be lighten.
6. To reset the LED signal please act according to
the steps described at the freestanding version.
Top of the miniBar
Right side wall (inside)
Figure 9.
Door (inside)
Dorr (inside
Back of miniBar
mm
Door front
Door front
Place of LED
GB
7