Publicité
Les langues disponibles
Les langues disponibles
The appliance must not be mounted directly adjacent to doors or under windows. Windows
opening or bursting open may knock hot cooking utensils off the hob.
Drawers should not be fitted underneath the hob.
Installation must be such as to ensure protection against shock.
The kitchen unit in which the appliance is fitted must satisfy the stability requirements of
DIN 68930.
For protection against moisture, all cut surfaces must be sealed with a suitable sealing
material.
On tiled work surfaces, the joints in the area where the hob is seated must be completely
filled with grout.
On natural, artificial stone or ceramic tops, the snap action springs must be bonded in place
with a suitable artificial resin or two-component adhesive.
The sealing strips must be adhered continuously along the outer edge of the ceramic glass
hob.
The sealing strips must overlap at the ends.
The sealing strips must not be stretched.
No additional silicone sealing mass must be applied as this will hinder removal for service
purposes.
To remove, the hob must be pushed out from below.
Clean the worktop around the cut-out area.
Electrical connection
DANGER!
Risk to life due to electrical current.
Voltage may be supplied to the mains terminal.
1. Please observe electrical engineering safety regulations.
2. Switch off the mains terminal.
IMPORTANT!
Damage due to electrical current.
Loose, incorrect terminal connections cause voltage flashovers.
1. Connect the mains supply to the correct terminals.
2. Provide cable with a strain relief feature.
3. Appliance cleaning (see „Before first-time use").
4. Check readiness for operation.
The appliance is connected electrically.
35
Publicité
