Télécharger Imprimer la page

KIKKA BOO LULLA Mode D'emploi page 8

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 19
(Figure 4.2) A. 7 colors light button,when press rst time, 7 colors light will be on.Press second time,then 7 colors light will be o .Notice:The visual e ect
of 7 colors light will be changed along with external environment.When external environment light is more stronger, visual e ect of 7 colors light will
be more weaker. On the contrary, when external environment light weak, visual e ect will more better. B. Rotating toys bar button; C. Power switch;
(Figure 4.3).Using 4 *1.5V AA batteries inside the main model: Put the batteries into main model: as shown, loosen the screw under a screwdriver, then
remove the battery cover and put the batteries into the correct polarity of the battery compartment, then cover and x the battery cover. Remove the
battery from the battery cover by the same steps.
Using adapter (Figure 4.4): Insert adapter DC plug into DC connector, AC plug into 100-240V 50/60Hz ;0.3A AC outlet.
A- DC Connector;
B- DC Plug;
C- AC plug can insert into the 0.3A AC socket with 100-240V, 50-60 HZ;
D- Output voltage of adapter 5-6V;
As below as Figure 4.5 shown use the screwdriver to take out the screws, remove the battery cover, put the batteries to the batterjar according to the
according to the correct polarity. The same way to take the batteries out from the battery jar.
1. Put the battery negative end into the battery box with spring end. 2. Put the battery convex part (positive end) into battery box with positive end. 3.
Close and xed battery cover with screw.
BATTERY WARNINGS:
• Non-rechargeable batteries are not to be recharged;
• Rechargeable battery can only be charged under adult supervision;
• Rechargeable battery should be taken out of the toys before charging;
• Di erent types of batteries or old and new batteries can not be mixed;
• The batteries should be placed in the correct polarity;
• Remove the exhausted batteries from the toys. Do not allow baby to play alone.
• Power supply terminal must not short-circuit;
V. PRODUCT FEATURES
Figure 5.1: Backrest 3 angle adjustment, rst pull the adjustable handle till to top,then carry it up,that can be changedsit position and lie position.
A-Lying position; B- Half lying position C-Sitting position;
Figure 5.2: Rotate the plastic toys bar. Toys bar can be rotated in a suitable position within limited range,which will
convenient for take baby out as below picture shown.
Figure 5.3: Folding the swing: 1. Pull seat both sides as arrows shown, can fold the seat. 2. When folding seat in third position (sitting position need
press this button to contunue folding. 3. After folding, fasten seat`s backreast belt with seat front snap button together. 4. Press main model and assist
model folding buttons, then folding iron tubes.
WARNING! THE BABY SHOULD LEAVE THE SWING BEFORE THE FOLDING OF IT!
CARE AND CLEANING
Seat pad: Remove from frame. Hand wash with cold water, gentle cycle.
Frame: Wipe the metal frame with soft, clean cloth and mild soap.
WARNING! NEVER MACHINE WASH, BLEACH, DEHYDRATE.
BASIC MAINTENANCE
1. If the music and swing stop: Wrong install way of batteries or low battery;
2. If no functions work when start up: Check whether the battery positive and negative on right station or check whether battery inside;
3. If press button, alarm song come out: Low battery, change new battery;
4. If shake seriously: Check the folding joint open completely or not;
5. If weak indicator light: Change new battery;
ENGLISH

Publicité

loading