KIKKA BOO LULLA Mode D'emploi page 7

WARNINGS
• Welcome to purchase this electric baby swing, this is the instruction together with the swing for you correctly and safe using the product.
• Please read the instruction of the swing carefully before using. It may cause injury to the infant if operating the swing not according to the instruction!
• Keep using seat belts always when baby on the seat!
• Never leave the child unattended when on swing!
• Suitable for 0-6 months or under 9 kgs!
• Never use toy bar to move or raise the swing!
• Never move or raise the swing when baby on seat!
• Never put others on toy bar except toys!
• Never use the swing in high place such as on desk, stairs to prevent injury!
• Keep swing in the at place always! It is dangerous to use this swing on an elevated surface,e.g. a table.
• Never use swing on soft place, to avoid su ocate(such as bed and sofa)!
• The product is not suitable for baby who already can walk or can sit alone!
• Not as a baby toy!
• Never fold when baby is in swing!
• Not use swing for long sleep!
• Make sure the player volume set in a low position!
• Don't use the product if any part miss, not use any alternative unless the manufacturer con rmed!
• Keep away from re ！
I. CONTENTS:
1- Front and back leg tube; 2- Main model; 3- Assist model; 4- Seat frame and seat cover; 5- Flower bud toys bar; 6- Petal toys The package
includes spare parts bag with manual, davit lid, plum blossom button, cap button, davit cover.
II. ASSEMBLY INSTRUCTIONS
WARNING! THIS ITEM ONLY CAN BE INSTALLED BY ADULT
2.1.Opening the support tube towards the two sides of main model and assist model (pressing down the button and meanwhile folding
the support tube towards the middle when folding this item).
NOTE: THE MAIN / ASSIST MODEL AXIS PROTECTIVE COVER IS NOT PART OF THE PRODUCT, JUST USE FOR PROTECT THE MAIN /
ASSIST MODEL AXIS WHEN PACKAGE (Figure 2.1, position 7).
2.2.insert the front and back leg tube into the support tube of main model and assist model and make sure the shrapnel inside the tube
should pop well.
2.3. Assembly the seat frame and plum blossom button, cap button and davit cover to the shaft of main model and assist model as shown
in Figure 2.3. Then try to pull the davit of seat frame to make sure installation well.
2.4.Flower toys installation. As shown in Figure 2.4,match under toys petal's assembled indication arrowswith upper toys petal's
arrows,connected with fours ones in proper order.1.First toys pedal`s groove match with owerbud`s lug boss, also connect with other 3
parts together, then toys petal will together with ower bud. 2. Combined complete picture.
2.5. As shown in Figure 2.5, insert the end of toy frame into the hole on the right davit arm base.
III. OPERATING INSTRUCTION
3. 1. Put the baby into the seat pad, lock the ve-point safety button according to below pictures, and then cover the seat pad bag. The length of the
safety belt can be adjusted by shoulder and waist button.
3.2. Fix the shoulder tape according to Figure 3.2.A-The tape is out from top. B-Overturn from bottom. C-Fasten the tape. D-Adjust shoulder and waist
belt length well.
IV. CONTROL PANEL INSTRUCTIONS (Figure 4.1)
A- Speed down button; B- Speed indicator lamp; C- Speed up button; D- Music button; E- Time setting button; F- Time indicator lamp;
Swing function: Five swing speeds available. Press "+" then speed up and the rst lamp on, press "-" the speed down and the lamp o . There are three
time setting available, press the rst time then one indicator lamp lights for 8 minutes, press the second one for 15 minutes, press the third one for 30
minutes, all the functions will stop once the settled time reach, then the swing will turn to rest situation to save electric. If don't start time setting
functions, all other functions started will continue working until power o . Music button: Press one time to start the music, press the second to fourth to
adjust the music volume bigger. Press the fth to stop music, press the sixth to play the next music (Total 12pcs 4 chords music).
ENGLISH