Wiring the accessories
For your safety, these operations must be carried out with the power supply switched off.
You are advised to perform auto-programming of the gate travel before connecting the accessories (photoelectric cells,
orange light, etc.)
Accessories general wiring diagram
Cells
It is not possible to connect a second set of photoelectric cells on this drive.
Installation
After wiring the photoelectric cells:
• switch the motor on again,
• start a gate opening or closing procedure.
The photoelectric cells are recognised by the control electronics once this movement is
complete.
Operation with photoelectric cells
If the cells are blocked when closing the gate, the gate will stop and reopen.
In the event of photoelectric cell disconnection
After disconnecting the photoelectric cells, switch the motor on again then perform the procedure "Deactivating automatic closing -
returning to standard operation" on page 14.
10
230 V power
supply
TX
RX
1 2
1 2 3 5