SOMFY EXAVIA 500 Mode D'emploi page 20

SAFETY INSTRUCTIONS
This symbol indicates a danger, the different
degrees of which are described below.
Indicates a danger which may result in immediate death
or serious injury
Indicates a danger which may result in death or serious
injury
Indicates a danger which may result in minor or moderate
injury
Indicates a danger which may result in damage to or
destruction of the product
CAUTION - Important safety instructions
For reasons of personal safety, it is important to follow all
the instructions, as incorrect installation can lead to serious
injury. Retain these instructions.
The installer must train all users to ensure the drive is
used in complete safety, in accordance with the operating
guide.
Instructions must be given to the final user.
1. Important information
This product is a for a hinged gate on a residential property as
defined in standard EN 60335-2-103, with which it is compliant.
The main purpose of these instructions is to satisfy the
requirements of the aforementioned standards and to ensure
the safety of equipment and persons.
To ensure compliance with the standard EN 60335-2-103, this
product must be installed with a Somfy motor. The assembly is
together designated as a "drive".
The use of any accessory or any component not
recommended by Somfy is prohibited, on safety grounds.
Somfy cannot be held liable for any damage resulting from
failure to follow the instructions in this manual.
If in any doubt when installing the motorisation or to obtain
additional information, consult the website www.somfy.
com.
The instructions may be modified if and when there is a
change to the standards or to the motorisation.
Before installing the drive, check that the temperature
range marked on the motors is suited to the location where
the drive is to be installed.
Do not spray water onto the motorisation.
Do not install the drive in an explosive environment.
4 4
DANGER
WARNING
PRECAUTION
CAUTION
WARNING
WARNING
CAUTION
2. Electrical installation
The installation of the power supply must comply with the
standards in force in the country in which the motorisation
is installed, and must be carried out by qualified personnel.
The electric line must be exclusively reserved for the
motorisation and equipped with protection, comprising:
• a 10 A fuse or breaker,
• a differential type device (30 mA).
An all-pole power supply cut-off device must be provided.
The switches provided to ensure a cut-out of all poles on
fixed appliances must be connected to the power supply
terminals and there must a separation between the
contacts on all poles to ensure complete disconnection
in conditions where category III high impulse voltage is
present.
Low-voltage cables subject to inclement weather must
be at least of type H07RN-F.
It is recommended that you fit a lightning conductor
(mandatory maximum residual voltage of 2 kV).
3. Safety instructions relating to
installation of the drive
Take off any jewellery (bracelet, chain, etc.) during
installation.
For manoeuvring, drilling and welding operations, wear
appropriate protection (special glasses, gloves, ear
protection, etc.).
Do not connect the motorisation to a power supply
(mains, battery or solar) until installation is complete.
Modifying one of the elements provided in this kit or using
an additional element not recommended in this manual is
strictly prohibited.
Monitor the gate as it moves and keep people away from it
until installation is complete.
Do not use adhesive to secure the motorisation.
WARNING
Install any fixed control device at a height of at least 1.5
m and within sight of the gate, but away from moving
parts.
A er installation, ensure that the drive changes direction
when the gate encounters a 50 mm object positioned
halfway up the leaf.
DANGER
DANGER
WARNING
DANGER
WARNING