Closing The Control Unit; Default Operation; Detecting Obstacles - SOMFY EXAVIA 500 Mode D'emploi

The gate movements must not be interrupted (complete opening/closing).
If they are interrupted, programming will resume the next time the opening command is issued.
If indicator light flashes, relaunch auto-programming of the leaf travel (4 full opening and closing movements).
If the indicator light continues flashing, consult the troubleshooting guide page 16.
If the gate re-opens at the end of the closing movement, loosen and offset the leaf brackets slightly towards the centre of the gate.
WARNING
Once installation is complete, it is essential to check that the obstacle detection complies with appendix A of the standard EN 12 453.
Checking the position of the aerial
For optimum performance, it is essential the aerial is correctly positioned.
Do not cut the cut the aerial wire.

Closing the control unit

Affix summary label (2) to the back of the control unit cover.
1
Close the control unit and screw in the cover.
2
Standy-by/Waking up the control electronics
Once the self-programming process has been completed, the electronics automatically switch to standby after 5 minutes of inactivity to save energy.
In standby mode, all indicator lights are switched off.
To check if the drive is switched on or to check/modify the parameter setting, press the
electronics will pass automatically to stand-by after 5 minutes of inactivity.

Default operation

Operating your gate in sequential mode and complete opening mode
Successive presses of the same remote control button will lead to the following movements of the gate: Open, Stop, Close, Stop, Open etc.

Detecting obstacles

When closing the gate, if an obstacle is detected (abnormal force on the motorisation), the gate stops then reopens
When opening the gate, if an obstacle is detected (abnormal force on the motorisation), the gate stops.
Aerial
button for 2 seconds to reactivate the electronics. The
9