Desa VO36NR Mode D'emploi page 7

INSTALLATION
Continued
INSTALLING DRAIN PAN DP36/DP42
The fireplace enclosure must allow for ad-
equate drainage and fresh air ventilation.
It is recommended that a sealed, corrosion
resistant catch pan with provision for drainage
be installed under fireplace within fireplace
enclosure (see Accessories, page 19).
INSTALLING FIREPLACE SCREEN
1. Insert each rod through all rings located
at top of screen.
2. Insert first rod into rear hole in left side
of fireplace. Fasten rod to rear hole near
center of fireplace using #10 x 3/8" Phillips
screw provided (see Figure 6).
3. Insert other rod into front hole on right side
of fireplace and fasten using remaining
Phillips screw.
Top View of Rod Layout
Rear Hole
Front
Hole
Rod
Ring
Screen
Figure 6 - Installing Fireplace Screen
INSTALLING FIREPLACE HOOD
HS36/HS42
1. Remove protective film from stainless
hood.
2. Align three notches located on back side
of hood with front face of fireplace (see
Figure 7). Notches should be at least 3
up from edge of fireplace opening.
3. Hold fireplace hood in place. Using a #10
drill bit, drill through three notches .
4. Insert three screws through notches in
hood into holes in fireplace.
119109-01G
Identification
Label Location
Screw
www.desatech.com
Notches
on Hood
Screws
Figure 7 - Installing Hood
INSTALLING BI-FOLD GLASS
DOORS
IMPORTANT: Use only glass
doors certified for use with this
fireplace (see Accessories,
page 19).
Door Installation
Pivot and spring clips have been installed
and pretested at the factory, but some read-
justments may be needed due to movement
during shipping or handling.
Install doors using the following steps. If you
find doors do not close properly or do not ap-
pear level or straight, proceed with section on
door adjustment.
1. With bi-fold door completely folded, insert
bottom pivot pin into pivot plate or pivot
hole located near bottom corner of front
face opening and swing door to the verti-
cal position making sure top pins slide into
door track. Door is installed when top door
pin snaps into spring clip (see Figure 8).
2. Repeat step 1 for remaining door.
Fold
Door and
Slide Top
Pins into
Track
/ "
1
2
Pivot Plate
or Pivot
Hole
Figure 8 - Installing Bi-Fold Door
Spring Clip
Insert Pin
into Spring
Clip
Insert Bottom
Pivot Pin into
Pivot Plate
or Hole and
Swing Door
into a Vertical
Position
7